Monday, September 17, 2012

Free Tutorial - Queen Victoria Cuff


 Queen Victoria Cuff
By Eva Marie Sherman

WireKnitZ® makes a beautiful canvas for vintage themed creations and you’ll feel as elegant as the Queen in this dramatic cuff!  Create the cuff, finish it with hand stitched grosgrain ribbon, and add a vintage pin for drama!

MATERIALS AND TOOLS
1 – 9” 3000 Series WireKnitZ®
Fireline® 4 lb. braided beading thread
2 – 6” x .5” Grosgrain Ribbon
1 – 30” x 1.5” Grosgrain Ribbon
3 – Sew-On Snaps
1 – Vintage Pin
Scissors
Tape Measure
Fabri-Tac™
Sewing Needle

STEP 1
Fold ribbon in half and make a seam 2” away from the fold
STEP 2
Open ribbon and make three folds on each side. Pin and then stitch in place.
STEP 3
Open WireKnitZ® tube and gently massage folded edges until smooth. At one end, gently pull outward with fingers until the end begins to roll outward and then roll three times to measure about ¼” wide. Press the roll down with fingers all the way around, burying the cut end. Repeat at opposite end.
STEP 4
Stretch each end to get a slight bell shape. Stitch rolled ends in place, if desired, though it is not necessary.
STEP 5
Make a cut down the length of the tube. Fold the 1/2” grosgrain ribbon in half lengthwise and pin in place along the cut edge of the WireKnitZ® tube. Tip: Before pinning to WireKnitZ®; create a soft crease in the grosgrain ribbon by gently ironing with a light weight towel to protect the ribbon.
STEP 6
Measure your wrist and size WireKnitZ® 1” larger than your wrist size. Depending upon wrist size, WireKnitZ® may be made larger by stretching width at ribbon edges, or made smaller by stretching length at rolled edges. To stretch, grasp opposing edges and gently pull, moving fingers along edges. Keep moving fingers around and pulling as WireKnitZ® begins to adjust in size. When the sheet is the correct size, stop stretching. A bit of trial and error may be required.
STEP 7
Line up the center of the tri-folded 1.5” grosgrain with the center of the WireKnitZ®, approx. ¾” from the top roll and pin centers together. Pin rest of ribbon in place, folding edges of ribbon under twice. Tip: Use Fabri-Tac to secure ends of ribbon.
STEP 8
Stitch grosgrain ribbon in place. Secure vintage pin at center of tri-folded ribbon.
STEP 9
Stitch sew-on snaps in place as shown.
Enjoy the complements!

1 comment:

Your comment will be published upon moderation.